What pad should go in a manufactured home?

A moisture-barrier pad, as standard rather than as an upgrade. These floors sit over open ground rather than a slab, and moisture moves up through the belly wrap and insulation continuously — particularly where that assembly has been damaged. A barrier pad keeps that from reaching the carpet and keeps spills from reaching the decking, which is the more expensive problem of the two.

Why is my carpet coming loose at the doorway?

Usually because the tack strip has pulled out of the decking. Particleboard or thin OSB that has taken any moisture loses its grip on a fastener, and the strip lifts under normal tension. Driving longer nails into the same compromised material does not fix it for long. The right repair is to replace the affected decking at the perimeter so the strip has sound material to hold, then re-stretch the carpet properly.

Carpet & Subfloor Prep in Willis, TX

County: Montgomery County
Drive time from our base: 20 min from our Montgomery crews

Free measure in Willis (713) 377-1303

What carpet & subfloor prep involves in Willis

Carpet remains a bigger share of the work in Willis than in the wealthier parts of the county, partly because the housing is more affordable and partly because a lot of it is manufactured, where carpet is genuinely a sensible choice — it is forgiving of a deck that flexes in a way that no hard surface is.

The manufactured-home specific is what goes under it. These floors sit above open ground rather than a slab, often with insulation and a belly wrap of varying condition beneath. Moisture moves up through that assembly, and a standard pad over a marginal deck holds it. We spec a moisture-barrier pad as default in manufactured homes here, and we still check the decking first — carpet is more forgiving of a soft deck than plank is, but a genuinely rotten section under carpet is a safety issue rather than a cosmetic one.

The other thing worth saying plainly is tack strip. Fastening tack strip into particleboard or thin OSB that has any moisture history is unreliable; it pulls loose and the carpet releases at the edge. Where the perimeter decking is questionable we address it rather than driving longer nails into it and hoping, because a carpet edge that lets go at a doorway becomes a trip hazard rather than merely an annoyance.

The job we run most here

Carpet and moisture-barrier pad through a manufactured home, with the perimeter decking checked and repaired where tack strip would not otherwise hold.

What it costs in Willis

Carpet and pad runs $3.50–$7 installed. The moisture-barrier pad we spec as standard in manufactured homes adds modestly and is worth it here. Decking repair at the perimeter, where needed, is quoted after probing.

What’s included

Carpet and pad supplied and delivered — seam layout planned before the roll is cut
Power-stretched carpet installation
Pad selection matched to traffic
Concrete grinding and patching
Self-leveling underlayment
Moisture mitigation systems

Materials we supply for this

Carpet & PadStill the right answer in bedrooms, media rooms, and rental turns — where warmth, quiet, and cost per foot matter most.$3.5–$7/sq ft installed

Questions we get in Willis

What pad should go in a manufactured home?: A moisture-barrier pad, as standard rather than as an upgrade. These floors sit over open ground rather than a slab, and moisture moves up through the belly wrap and insulation continuously — particularly where that assembly has been damaged. A barrier pad keeps that from reaching the carpet and keeps spills from reaching the decking, which is the more expensive problem of the two.
Why is my carpet coming loose at the doorway?: Usually because the tack strip has pulled out of the decking. Particleboard or thin OSB that has taken any moisture loses its grip on a fastener, and the strip lifts under normal tension. Driving longer nails into the same compromised material does not fix it for long. The right repair is to replace the affected decking at the perimeter so the strip has sound material to hold, then re-stretch the carpet properly.

All areasCarpet & Subfloor PrepThe full scope, materials, and gallery across every city we serve.All servicesFlooring in Willis, TXEverything we install in Willis, and what the housing stock here needs.